Dimensions weight Elbow male and female EN 10241

EN 10241:2000 Steel threaded pipe fittings

All dimensions are in "mm" and All weights are in "kg" unless noted otherwise specified.

you may also check non standard sizes pipe fitting weight online calculation, pipe fitting surface area online calculation,pipe fitting surface volume online calculation from our pipeline tool link:


The whole weight and dimension list of pipe fitting directory


Download the BS EN 10241 PDF file: BS EN 10241 Steel threaded pipe fittings



Nominal size
Centre to face
Centre to face
Bore of male end
819276 58 0
1021298 510 5
15253511 513 0
20304018 021 0
25374624 026 0
32435430 032 0
40495737 039 0
50597048 051 0
65688362 066 0
80819475 079 0
10010011597 0104 0

1) The outside diameter is a minimum for all fittings except equal sizes of socket and half socket. The minimum outside diameters of equal sizes of socket and half socket are given in Tables 11 and 12.

2) are minimum and maximum diameters for tubulars in Tables 21 to 24; for other fittings only the minimum is applicable.
3) The value is not applicable to bushes described in Table 15.
4) Wall thickness tolerances for tubulars shall be:
no limit in plus;
12 5 % minus.


1. Scope

European Standard EN 10241 specifies requirements for screw threaded fittings of nominal sizes from DN 6 to DN 150 inclusive,made out of welded steel or seamless steel tubes,forging and rolled bars.It is applicable to those screw threaded steel pipe fittings used in the transportation and distribution of liquid or gas.

2.Normative references

This European Standard incorporates by dated or undated reference,provisions from other publications.These normative references are cited at the appropriate places in the text and the publications are listed hereafter.For dated references,subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporate in it by amendments or revision.For undated references,the latest edition of the publication referred to applies (including amendmens).

EN 10204,Metallic products-Types of inspection documents.

EN ISO 6708,Pipework components-Definition and selection of DN (nominal size) (ISO 6708:1995).

ISO 7-1: Pipe Threads where Pressure-Tight Joints are made on the Threads;Part 1: Dimensions,Tolerances and Designation.

ISO 7-2: Pipe Threads where Pressure-Tight Joints are made on the Threads;Part 2:Verification by means of Limit Gauges.

ISO 228-1: Pipe threads where pressure-tight joints are not made on the threads–Part 1: Dimensions,tolerances and designation.

ISO 228-2: Pipe threads where pressure-tight joints are not made on the threads-Part 2: Verification by means of limit gauges .